Eleaf i Just S 3000 mAh Product Review Installation and Operation
The Eleaf i Just S package contains 3 Eleaf EC Coils. The installed coil is 0.3 ohm, the replacement coil is 0.5 ohm and 0.18 ohm. The package also includes a USB cable operation keyboard and air control ring. Although it is set on the air duct in most electronic cigarettes, the eleaf i just s can be adjusted with the Air control ring. To switch the device on / off, simply insert the battery and press the ignition button 5 times. This should be done in as little as 1-2 seconds. Make sure the coil is damp when firing. If you fire with a dry coil, cotton will burn.
The Eleaf i Just S electronic cigarette battery (3000mAh) is sufficient for daytime use. If you use it intensively, it is charged easily with the computer or powerbank. Charging time is about 3.5 hours on empty battery. Liquid filling is very easy. The top cap of the top cap atomizer can be turned by turning and filling liquid can be done through wide channels on the edge. The central part is for air passage. Take care not to get liquid from this part. If you fill the liquid from this part, it will pass directly through the inside of the coil and cause a leakage through the air duct.
The Atomizer of the Eleaf i Just S electronic cigarette is similar to the Melo 3 mini. Of course, it has a large liquid capacity of 4ml in size. Separating parts for atomizer cleaning is quite simple. Atomizer is turned on by turning from base and top cap. Driptip and glass pull-out is not a screw system. In every new coil, moistening the cotton with 1-2 drops of liquid from the cotton parts on the edge of the coil will be very beneficial for the health of the coil.
The Eleaf i Just S electronic cigarette is easy to use and the light on the button is also a battery indicator. If the battery charge is between 60% and 100%, the light will turn on steadily during ignition, 30% to 59% light will blink slowly, 10% to 29% will blink fast, Battery 0% to 9% light will blink very fast. charge the battery.
The ignition protection will be activated in case the Eleaf i Just S electronic cigarette has been pressed for a long time. When pressed for 15 seconds, the light will flash 10 times and the ignition will be deactivated.
If the ignition key is pressed without the atomizer connected, the light will flash slowly and will not output.
If the coil is faulty or a coil less than 0.15ohm is installed, the light will flash 3 times, it is necessary to check or replace the coil.
If the undervoltage protection battery output voltage drops below 3.3V, the light will flash 40 times, so you need to charge it.
Recommended Installation and Usage:
If you just bought your Eleaf i Just S electronic cigarette, charge the mode first via the computer, turn on the atomizer and drop 1-2 drops of liquid from the cotton parts on the sides of the coil, then turn off the atomizer and wait at least 15 minutes. Do not fill the liquid too much during the initial filling. Half level is ideal.
The device is switched on / off by pressing the ignition button 5 times. Shooting is performed with the button pressed.
Warnings Precautions:
Do not use your Eleaf i Just S electronic cigarette in dusty environments. Connect the USB port and charger correctly. Do not ignite while charging. Do not put the device directly in your pocket or purse. Do not mix with materials that affect the exterior, such as money / key. Do not place in extreme temperatures. Do not attempt to disassemble the internal battery. Please switch off the device when not in use. In case of glass breakage, I recommend using Vape band. 1 amp output devices such as computer powerbank are suitable.
You can click on the product link below to buy Eleaf i Just S Kit Electronic Cigarette.
